Hello,
I got an LHI quadcopter set from my girlfriend and have already mastered soldering it together.
After a few hours I had then also installed the FW and the configuration of the FC with Betaflight. So far so good. The engines turn. albeit all in one direction. at least in the beta flight test.
My real problem is that the receiver doesn't respond to anything. I've bound both and I can see the drone's battery on the remote, but the drone doesn't respond to a single button.
In the modes I put "ARM" on AUX 1 and put Channel 5 on SWA in the remote control.
If I now activate SWA, it should turn yellow in the Betaflight modes menu. but nothing happens :-/.
Do I have to configure anything else than just flight controllers?
I should perhaps mention that I am a total beginner when it comes to assembling and configuring.
I got an LHI quadcopter set from my girlfriend and have already mastered soldering it together.
After a few hours I had then also installed the FW and the configuration of the FC with Betaflight. So far so good. The engines turn. albeit all in one direction. at least in the beta flight test.
My real problem is that the receiver doesn't respond to anything. I've bound both and I can see the drone's battery on the remote, but the drone doesn't respond to a single button.
In the modes I put "ARM" on AUX 1 and put Channel 5 on SWA in the remote control.
If I now activate SWA, it should turn yellow in the Betaflight modes menu. but nothing happens :-/.
Do I have to configure anything else than just flight controllers?
I should perhaps mention that I am a total beginner when it comes to assembling and configuring.
