I recently switched from a T14SG to another T14SG.
I use two R7008SB in dual mode.
Now the problem is that the voltage from my copter often drops to 0 V for a few seconds. The displayed signal strength is also completely gone for a short time.
However, you don't notice anything in flight, so control commands are received without any problems.
I also have the problem that my telemetry data from the GPS sensor is no longer being transmitted. Wanted to add it again, but got a message that it already exists.
What can be there?
I use two R7008SB in dual mode.
Now the problem is that the voltage from my copter often drops to 0 V for a few seconds. The displayed signal strength is also completely gone for a short time.
However, you don't notice anything in flight, so control commands are received without any problems.
I also have the problem that my telemetry data from the GPS sensor is no longer being transmitted. Wanted to add it again, but got a message that it already exists.
What can be there?
